LM5176PWPR.B datasheet(13/45 Pages) TI2

13 / 45 page

7 Detailed Description

7.1 Overview

The LM5176 is a wide input voltage four-switch buck-boost controller IC with integrated drivers for N-channel

MOSFETs. It operates in buck mode when VIN is greater than VOUT and in boost mode when VIN is less than

VOUT. When VIN is close to VOUT, the device operates in a proprietary transition buck or boost mode. The control

scheme provides smooth operation for any input/output combination within the specified operating range. The

buck or boost transition control scheme provides a low ripple output voltage when VIN equals VOUT without

compromising the efficiency.

The LM5176 integrates four N-Channel MOSFET drivers including two low-side drivers and two high-side

drivers, eliminating the need for external drivers or floating bias supplies. The internal VCC regulator supplies

internal bias rails as well as the MOSFET gate drivers. The VCC regulator is powered either from the input

voltage through the VIN pin or from the output or an external supply through the BIAS pin for improved efficiency.

The PWM control scheme is based on valley current mode control for buck operation and peak current mode

control for boost operation. The inductor current is sensed through a single sense resistor in series with the

low-side MOSFETs. The sensed current is also monitored for cycle-by-cycle current limit. The behavior of the

LM5176 during an overload condition is dependent on the MODE pin programming (see the Section 7.4.2

section). If hiccup mode fault protection is selected, the controller turns off after a fixed number of switching

cycles in cycle-by-cycle current limit and restarts after another fixed number of clock cycles. The hiccup mode

reduces the heating in the power components in a sustained overload condition. If hiccup mode is disabled

through the MODE pin, the controller remains in a cycle-by-cycle current limit condition until the overload is

removed.

In addition to the cycle-by-cycle current limiting, the LM5176 also provides an optional average current regulation

loop that can be configured for either input or output current limiting. This is useful for battery charging or other

applications where a constant current behavior may be required.

The soft-start time of LM5176 is programmed by a capacitor connected to the SS pin to minimize the inrush

current and overshoot during start-up.

The precision EN/UVLO pin supports programmable input undervoltage lockout (UVLO) with hysteresis. The

output overvoltage protection (OVP) feature turns off the high-side drivers when the voltage at the FB pin

exceeds the output overvoltage threshold (VOVP). The PGOOD output indicates when the FB voltage is inside

the PGOOD regulation window centered at VREF.

www.ti.com

LM5176

SNVSAI1D – JUNE 2017 – REVISED AUGUST 2021

Submit Document Feedback

Product Folder Links: LM5176

LM5176PWPR.B Datasheet(PDF) 13 Page - Texas Instruments