Single Phase Bridge Rectifiers

CP80 Series

Page <1>

13/06/12 V1.1

www.element14.com

www.farnell.com

www.newark.com

Features:

•• High surge current capability

•• PCB mounted / screw fixing

•• Surge overload rating: 200 A peak

•• Low forward voltage drop and reverse leakage

•• Small size, simple installation

•• Reliable low cost construction utilizing moulded plastic technique

Mechanical Data:

Mounting Position

: Any

Terminals

: Leads solderable per

MIL-STD- 202, Method 208

Mounting

: Through hole for a number 6 screw

Dimensions : Inches (Millimetres)

Maximum Ratings and Electrical Characteristics

At 25°C ambient temperature unless otherwise noted; resistive or inductive load at 60 Hz

Parameter

CP802

CP806

Unit

Maximum Recurrent Peak Reverse Voltage

200

600

V

Maximum Bridge Input Voltage RMS

140

420

Maximum Average Rectified Output at

TC = 50°C

See Figure 2

TA = 40°C

8

3

A

Peak One Cycle Surge Overload Current

200

Maximum Forward Voltage Drop Per Element at 4 A dc and 25°C

See Figure 3

1.1

V

Maximum Reverse Leakage at Rated DC Blocking Voltage Per Element at 25°C

See Figure 4

at 100°C

10

1

µA

mA

I2t Rating for Fusing ( t<8.3 ms)

166

A2s

Typical Junction Capacitance Per Leg (Note 4) CJ

200

pF

Typical Thermal Resistance Per Leg (Note 3) R

θJA

Typical Thermal Resistance Per Leg (Note 2) R

θJL

21

6

°C / W

Operating Temperature Range

-55 to +125

°C

Storage Temperature Range

-55 to +150

Notes : 1. Bolt down on to a heat-sink with silicon thermal compound between bridge and mounting surface for maximum heat

transfer with a number 6 screw

2. Units mounted on a 8.6 × 8.6 × 24 inches thick (22 × 22 × 0.6 cm) aluminium plate heatsink

3. Units mounted on PCB at 0.375 inches (9.5 mm) lead length with 0.5 × 0.5 inches (12 × 12 mm) copper pads

4. Measured at 1 MHz and applied reverse voltage