PROLINE G2 INtERNaL COmPONENts Panels and accessories

nVent.com/HOFFMAN

SUBJECT TO CHANGE WITHOUT NOTICE

mOduLaR ENCLOsuRE sOLutIONs

1

Spec-01198 D

Spec-01198

FuLL subPaNEL (REaR OR sIdE)

aPPLICatION

The PROLINE G2 Subpanel is part of the new patent pending EZ-

Load Mounting System which was designed to maximize space

utilization and to make loading the subpanel faster and safer

by providing a variety of loading options. The EZ-Load Glide

Blocks can be used to load a subpanel vertically from the front,

rear or side. Additionally, they can be used to load the subpanel

horizontally—a new method for a more controlled option to load a

subpanel into a modular enclosure.

FEatuREs

•

Accommodates five loading options: vertical front, vertical side,

vertical rear, horizontal front (frame over subpanel), horizontal

rear (subpanel lowered into frame)

•

Large mounting subpanel; maximum internal space efficiency

•

Mounting subpanel is securely fastened at the top and bottom of

the enclosure

sPECIFICatIONs

•

Subpanels systems less than 1200mm wide include four sets of

EZ-Load Glide Blocks, four BV-M6 fasteners (block to frame) and

four M12 Hex Bolts (subpanel to block)

•

Subpanel systems 1200mm and greater include eight sets of

EZ Load Glide Blocks, eight BV-M6 fasteners (block to frame)

and eight M12 Hex Bolts (subpanel to block) to ensure wider

subpanels are well supported

•

Subpanels can be mounted at any depth in 25-mm increments

(front to back)

•

Accommodates back-to-back subpanels and fully recessed rear

position

•

Panels can be installed in the rearmost position, or positioned so

joined enclosures provide a continuous mounting surface without

requiring joining panels

•

High space efficiency ratio (HxW of subpanel)/(HxW of frame) of

84 percent

•

Side-mount panels must be used for the sides of the enclosure;

they can be installed on the interior sides of frames

•

Widths of 1200 mm are 10 gauge (3.0 mm) mild steel; widths less

than 1200 mm are 12 gauge (2.5 mm)

•

Conductive (galvanized/plated) or painted options

•

Optional panel support bracket available for applications

requiring more support in the center of the subpanel; this is

required if the enclosure will be tipped in transit or if the panel is

not located at the bottom of the enclosure on the glide blocks

•

Optional panel support brace for the bottom of the enclosure

provides additional support for heavy loads

FINIsH

•

Painted polyester powder paint; white

•

Custom colors available

LOad RatING

•

2000 lbs (907 kg), safety factor 2.5; frame size: 2000x600x800

mm (load ratings vary by frame size)

aCCEssORIEs

•

Joining Subpanels

•

Panel Support Bracket

•

Panel Support Brace

Bulletin: p40