4

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

10. NEVER use the tool if it is defective or operating abnormally.

11. ALWAYS disconnect from the air supply when:

• Performing any maintenance.

• The tool is not in use.

• The tool will be left unattended.

• Moving to another work area.

• Passing the tool to another person.

12. Avoid damaging the tool by applying excessive force of any kind.

13. ALWAYS maintain the tool with care. Keep it clean for the best and safest

performance.

14. Quick change couplings should not be located at the tool. They add

weight and could fail due to vibration.

15. DO NOT force or misuse the tool. It will do a better and safer job at the rate

for which it was designed.

16. This tool vibrates with use. Vibration may be harmful to your hands or arms.

Stop using the tool if discomfort, a tingling feeling or pain occurs. Seek

medical advice before resuming use.

USE OF THE POLISHING TOOL

1. Try to hold the tool with both hands. Ensure that the workpiece is kept at

waist height where possible. NEVER use the tool between the legs whilst

sitting on the floor.

2. ALWAYS allow the tool to run up to full operating speed before applying it

to the job.

3. Use clamps, or vices to hold a loose workpiece. Failure to secure the

workpiece could result in personal injury.

4. Inspect the pad/mop before use. DO NOT use if split or torn.

5. ALWAYS wear a face mask as protection from airbourne particles. Avoid

disturbing existing dust and minimise the scattering of dust in the worplace

environment. Take steps to control the dust at the point of emission.

TRANSPORTATION AND STORAGE

1. NEVER carry the tool by the air supply hose.

2. NEVER carry the tool with your finger on the trigger.

3. When not in use the tool should be disconnected from the air supply and

stored in a dry place out of the reach of children.

4. Avoid storing the tool in environments where the temperature is below 0oC.