(7) Do not apply stress to the LSI chips and the surrounding molded sections.

(8) Do not disassemble nor modify the OLED display module.

(9) Do not apply input signals while the logic power is off.

(10) Pay sufficient attention to the working environments when handing OLED display modules

to prevent occurrence of element breakage accidents by static electricity.

* Be sure to make human body grounding when handling OLED display modules.

* Be sure to ground tools to use or assembly such as soldering irons.

* To suppress generation of static electricity, avoid carrying out assembly work under dry

environments.

* Protective film is being applied to the surface of the display panel of the OLED display

module. Be careful since static electricity may be generated when exfoliating the protective

film.

(11) Protection film is being applied to the surface of the display panel and removes the

protection film before assembling it. At this time, if the OLED display module has been

stored surface of the display panel after removed of the film. In such case, remove the

residue material by the method introduced in the above Section 5.

(12) If electric current is applied when the OLED display module is being dewed or when it is

placed under high humidity environments, the electrodes may be corroded and be careful

to avoid the above.

Storage Precautions

(1) When storing OLED display modules, put them in static electricity preventive bags avoiding

exposure to direct sun light nor to lights of fluorescent lamps. And, also, avoiding high

temperature and high humidity environment or low temperature (less than 0°C)

environments.(We recommend you to store these modules in the packaged state when

they were shipped from

Midas Displays. At that time, be careful not to let water drops

adhere to the packages or bags nor let dewing occur with them.

(2) If electric current is applied when water drops are adhering to the surface of the OLED

display module, when the OLED display module is being dewed or when it is placed under

high humidity environments, the electrodes may be corroded and be careful about the

above.

Designing Precautions

(1) The absolute maximum ratings are the ratings which cannot be exceeded for OLED display

module, and if these values are exceeded, panel damage may be happen.

(2) To prevent occurrence of malfunctioning by noise, pay attention to satisfy the VIL and VIH

specifications and, at the same time, to make the signal line cable as short as possible.

(3) We recommend you to install excess current preventive unit (fuses, etc.) to the power

circuit (VDD). (Recommend value: 0.5A)

(4) Pay sufficient attention to avoid occurrence of mutual noise interference with the

neighboring devices.

(5) As for EMI, take necessary measures on the equipment side basically.

(6) When fastening the OLED display module, fasten the external plastic housing section.

(7) If power supply to the OLED display module is forcibly shut down by such errors as taking

out the main battery while the OLED display panel is in operation, we cannot guarantee the

quality of this OLED display module. Connection (contact) to any other potential than the

above may lead to rupture of the IC.

Page 15 of 15