13 - 14

13

For price, delivery, and to place orders: Analog Devices, Inc., One Analog Way, Wilmington, MA 01887

Phone: 781-937-1428 • Order online at www.analog.com

Application Support: Phone: 1-800-ANALOG-D

HMC981LP3E

v02.1222

ACTIVE BIAS CONTROLLER

Figure 1. Daisy Chain Operation

Operation Modes

HMC981LP3E can be configured to bias both enhancement and depletion mode external amplifiers. The mode of

operation can be selected by setting two pins (VNEGFB, VGATEFB) as tabulated in Table-2. The connection to the

VNEGIN should be adjusted accordingly.

In order not to bias external amplifier in a wrong region, please make sure that the correct mode of operation is

selected before powering up the HMC981LP3E.

The HMC981LP3E does not allow the internal negative voltage generator to work if an enhancement mode is selected.

Therefore, if VNEGFB is left floating while VGATEFB is grounded, HMC981LP3E will stay in standby mode.

Please note that the external negative voltage should be between -2.5V to -3.5V for HMC981LP3E to operate. If your

application requires negative voltages outside this range please contact Hittite application support.

Table 2. Mode Selection

VNEGFB

VGATEFB

VNEGIN

Description

MODE1

(Depletion/Master Mode)

FLOAT

FLOAT

Connected to

VNEGOUT

Depletion mode transistor. Internal negative voltage generator is

active and generates -2.5V. Sample application schematic given

shown in Fig.2a.

MODE2

(Depletion/Slave Mode)

GND

FLOAT

Connected to

External VSS

Depletion mode transistor. Internal negative voltage generator is

disabled. An external negative voltage less than -2.3V should be

connected to VNEGIN. Sample application schematic given shown

in Fig.2b.

---

FLOAT

GND

N/A

Not allowed. HMC981LP3E stays in standby.

MODE3

(Enhancement Mode)

GND

GND

Connected to

GND

Enhancement mode transistor. Internal negative voltage generator is

disabled. Sample application schematic given shown in Fig.2c.