STCF03ITBR datasheet(15/33 Pages) STMICROELECTRONICS

Part #	STCF03ITBR

Description	High power white LED driver with I²C interface

PDF	33 Pages

Scroll/Zoom	100%

Manufacturer	STMICROELECTRONICS [STMicroelectronics]

Direct Link	http://www.st.com

Logo

15 / 33 page

Introduction

STCF03I

15/33

7.3

I²C bus interface

Data transmission from the main µP to STCF03I and vice versa takes place through the 2

I²C bus interface wires, consisting of the two lines SDA and SCL (pull-up resistors to a

positive supply voltage must be externally connected). The recommended maximum voltage

of these signals should be 3.0 V.

7.4

Data validity

As shown in Figure 5, the data on the SDA line must be stable during the high period of the

clock. The HIGH and LOW state of the data line can only change when the clock signal on

the SCL line is LOW.

7.5

Start and stop conditions

Both DATA and CLOCK lines remain HIGH when the bus is not busy. As shown in Figure 6,

a start condition is a HIGH to LOW transition of the SDA line while SCL is HIGH. The stop

condition is a LOW to HIGH transition of the SDA line while SCL is HIGH. A STOP condition

must be sent before each START condition.

Figure 5.

Data validity on the I²C Bus

Figure 6.

Timing diagram on I²C Bus

STCF03ITBR Datasheet(PDF) 15 Page - STMicroelectronics