M16CSLASH29 datasheet(235/499 Pages) RENESAS

235 / 499 page

14. Serial I/O

page 211

Figure 14.30 Bus Collision Detect Function-Related Bits

(2) The ACSE bit in the U2SMR register (auto clear of transmit enable bit)

(1) The ABSCS bit in the U2SMR register (bus collision detect sampling clock select)

If ABSCS=0, bus collision is determined at the rising edge of the transfer clock

Transfer clock

Timer A0

(3) The SSS bit in the U2SMR register (Transmit start condition select)

Transmission enable condition is met

If SSS bit = 1, the serial I/O starts sending data at the rising edge (Note 1) of RxD2

TxD2

CLK2

TxD2

RxD2

TxD2

RxD2

Input to TA0IN

If ABSCS is set to 1, bus collision is determined when timer

A0 (one-shot timer mode) underflows

TxD2

RxD2

Transfer clock

BCNIC register

IR bit (Note)

U2C1 register

TE bit

If ACSE bit is set to 1

automatically clear when bus collision

occurs), the TE bit is cleared to 0

(transmission disabled) when

the IR bit in the BCNIC register is

set to 1 (unmatching detected).

If SSS bit is set to 0, the serial I/O starts sending data one transfer clock cycle after the transmission enable condition is met.

Transfer clock

(Note 2)

NOTES:

1: The falling edge of RxD2 when the IOPOL is set to 0; the rising edge of RxD2 when the IOPOL is set to 1.

2: The transmit condition must be met before the falling edge (Note 1) of RxD.

This diagram applies to the case where the IOPOL is set to 1 (reversed)

M16C/29 Datasheet(PDF) 235 Page - Renesas Technology Corp