| Electronic Components Datasheet Search |
|
TDA7272A Datasheet(PDF) 8 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
TDA7272A Datasheet(HTML) 8 Page - STMicroelectronics |
|
8 / 16 page ![]() Pin 9 Output motor left. The four power transistors are realized as darlington structures. The arrange- ment is controlled by the logic status at pins 18 and 19. As before explained (see block description), in the normal left or right mode one of the lower dar- lington becomes saturated whereas the other re- mains open. The upper half of the bridge oper- ates in the linear mode. In stop condition both upper bridge darlingtons are off and both lower are on. In the high output impedance state the bridge is switched com- pletely off. Connecting the motor between pins 9 and 12 both left or right rotation can be obtained. If only one rotation sense is used the motor can be con- nected at only one output, by using only the upper bridge half. Two motors can be connected each at the each output : in such case they will work al- ternatively (see application section). The internal diodes, together with the collector substrate diodes, protect the output from induc- tive vol-tage spikes during the transition phase (fig. 10) Pin 10 Common sense output. From this pin the output current of the bridge configuration (motor current) is fed into RS external resistor in order to gener- ate a proper voltage drop. The drop is supplied into pin 1 for tachometric control and into pin 8 for V/I control (see pin 1 and pin 8 sections). Pin 11 Supply voltage. Pin 12 Output motor right. (see pin 9 section) Pin 13 Output main amplifier. The voltage on this pin re- sults from the tachometric speed control and feeds the output stage. The value of the capacitor CF (fig. 11), connected from pins 13 and 14, must be chosen low enough in order to obtain a short reaction time of the tachometric loop, and high enough in order to re- duce the output ripple. A compromise is reached when the ripple voltage (peak-to-peak) VROP is equal to 0.1 VMOTOR : CF = 2.3 CT VRIP ( 1 − RT RP ) with VRIP = VFEM + IMOT ⋅ RMOT 10 and with duty cy- cle = 50 %. (see pin 2-3 section) Figure 8. Figure 9. Figure 10. TDA7272A 8/16 |
|
|
Link URL |
| Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link to Datasheet | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |