LTC1063CSW datasheet(8/16 Pages) LINER

8 / 16 page

LTC1063

1063fa

V–

50k

V+

0.1

µF

VOUT

1063 TC01

0.1

µF

CLOCK IN

–

LT1022

20pF

VIN

50k

LTC1063

CLOCK FREQUENCY (MHz)

200

180

160

140

120

100

310

1063 F02

6 78 9

VS = ±2.5V

VS = ±5V

VS = ±7.5V

TA = 25°C

Output Pin (Pin 7, N Package)

Pin 7 is the filter output. This pin can typically source over

20mA and sink 2mA. Pin 7 should not drive long coax

cables, otherwise the filter’s total harmonic distortion will

degrade.

Clock Input Pin (Pin 5, N Package)

An external clock when applied to pin 5 tunes the filter

cutoff frequency. The clock-to-cutoff frequency ratio is

100:1. The high (VHIGH) and low (VLOW) clock logic

threshold levels are illustrated in Table 2. Square wave

clocks with duty cycles between 30% and 50% are strongly

recommended. Sinewave clocks are not recommended.

Clock Output Pin (Pin 4, N Package)

Any external clock applied to the clock input pin appears

at the clock output pin. The duty cycle of the clock output

equals the duty cycle of the external clock applied to the

clock input pin. The clock output pin swings to the power

supply rails. When the LTC1063 is used in a self-clocking

mode, the clock of the internal oscillator appears at the

clock output pin with a 30% duty cycle. The clock output

pin can be used to drive other LTC1063s or other ICs. The

maximum capacitance, CL(MAX), the clock output pin can

drive is illustrated in Figure 2.

Table 2. Clock Pin Threshold Levels

POWER SUPPLY

VHIGH

VLOW

VS = ±2.5V

1.5V

0.5V

VS = ±5V

VS = ±7.5V

4.5V

1.5V

VS = ±8V

4.8V

1.6V

VS = 5V, 0V

VS = 12, 0V

9.6V

7.2V

VS =15V, 0V

12V

Figure 3. Test Circuit for THD

Figure 2. Maximum Load Capacitance at the Clock Output Pin

TEST CIRCUIT

PI FU CTIO S

LTC1063CSW Datasheet(PDF) 8 Page - Linear Technology

LTC1063CSW Datasheet(HTML) 8 Page - Linear Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Datasheet Download

Link URL