TL1454, TL1454Y

DUAL-CHANNEL PULSE-WIDTH-MODULATION (PWM)

CONTROL CIRCUIT

SLVS086B – APRIL 1995 – REVISED NOVEMBER 1997

5

POST OFFICE BOX 655303

POST OFFICE BOX 1443

error amplifier

R1 and R2 should be tight-tolerance (

±1% or better) devices with low and/or matched temperature coefficients

to minimize output voltage errors. A device with a

±5% tolerance is suitable for R3.

_

+

IN –

IN +

R2

COMP

To PWM

VO

Compensation

Network

REF

R1

R3

Converter

Output

Figure 2. Sense Divider/Error Amplifier Configuration for Converters with Negative Outputs

Figure 2 shows the divider network and error-amplifier configuration for negative output voltages. In general,

the comments for positive output voltages also apply for negative outputs. The output voltage is given by:

V

O +*

R

1

V

ref

R

2

The design procedure for choosing the resistor value is to select a convenient value for R2 (instead of R3 in

the procedure for positive outputs) and calculate R1 and R3 using:

R

1 +*

R

2

V

O

V

ref

R

3 +

R

1

R

2

R

1 )

R

2

Values in the 10-k

Ω to 20-kΩ range work well for R2. R3 can be omitted and the noninverting amplifier connected

to ground in applications where the output voltage tolerance is not critical.

oscillator

The oscillator frequency can be set between 50 kHz and 2 MHz with a resistor connected between RT and GND

operating frequency. Both components should be tight-tolerance, temperature-stable devices to minimize

RT

CT

RT

CT

TL1454

21

Figure 3. Oscillator Timing