TLC25M2ACD datasheet(20/21 Pages) TI

20 / 21 page

TLC252, TLC252A, TLC252B, TLC252Y, TLC25L2, TLC25L2A, TLC25L2B

TLC25L2Y, TLC25M2, TLC25M2A, TLC25M2B, TLC25M2Y

LinCMOS

™ DUAL OPERATIONAL AMPLIFIERS

SLOS002G – JUNE 1983 – REVISED AUGUST 1996

POST OFFICE BOX 655303

• DALLAS, TEXAS 75265

APPLICATION INFORMATION

latch-up avoidance

Junction-isolated CMOS circuits have an inherent parasitic PNPN structure that can function as an SCR. Under

certain conditions, this SCR may be triggered into a low-impedance state, resulting in excessive supply current.

To avoid such conditions, no voltage greater than 0.3 V beyond the supply rails should be applied to any pin.

In general, the operational amplifier supplies should be applied simultaneously with, or before, application of

any input signals.

output stage considerations

The amplifier’s output stage consists of a source-follower-connected pullup transistor and an open-drain

pulldown transistor. The high-level output voltage (VOH) is virtually independent of the IDD selection and

increases with higher values of VDD and reduced output loading. The low-level output voltage (VOL) decreases

with reduced output current and higher input common-mode voltage. With no load, VOL is essentially equal to

the potential of VDD–/GND.

supply configurations

Even though the TLC252 / 25_2C series is characterized for single-supply operation, it can be used effectively

in a split-supply configuration if the input common-mode voltage (VICR), output swing (VOL and VOH), and supply

voltage limits are not exceeded.

circuit layout precautions

The user is cautioned that whenever extremely high circuit impedances are used, care must be exercised in

layout, construction, board cleanliness, and supply filtering to avoid hum and noise pickup, as well as excessive

dc leakages.

TLC25M2ACD Datasheet(PDF) 20 Page - Texas Instruments