| Electronic Components Datasheet Search |
|
TLV2341IPWLE Datasheet(PDF) 2 Page - Texas Instruments |
|
|
|||||||||||||||||||||||||||||
TLV2341IPWLE Datasheet(HTML) 2 Page - Texas Instruments |
|
2 / 51 page ![]() TLV2341, TLV2341Y LinCMOS ™ PROGRAMMABLE LOW-VOLTAGE OPERATIONAL AMPLIFIERS SLOS110A – MAY 1992 – REVISED AUGUST 1994 2 POST OFFICE BOX 655303 • DALLAS, TEXAS 75265 bias-select feature The TLV2342 offers a bias-select feature that allows the user to select any one of three bias levels, depending on the level of performance desired. The tradeoffs between bias levels involve ac performance and power dissipation (see Table 1). Table 1. Effect of Bias Selection on Performance TYPICAL PARAMETER VALUES MODE TYPICAL PARAMETER VALUES TA = 25°C, VDD = 3 V HIGH BIAS RL = 10 kΩ MEDIUM BIAS RL = 100 kΩ LOW BIAS RL = 1 MΩ UNIT PD Power dissipation 975 195 15 µW SR Slew rate 2.1 0.38 0.02 V/ µs Vn Equivalent input noise voltage at f = 1 kHz 25 32 68 nV/ √Hz B1 Unity-gain bandwidth 790 300 27 kHz φm Phase margin 46 ° 39 ° 34 ° AVD Large-signal differential voltage amplification 11 83 400 V/mV bias selection Bias selection is achieved by connecting BIAS SELECT to one of three voltage levels (see Figure 1). For medium-bias applications, it is recommended that the bias-select pin be connected to the midpoint between the supply rails. This procedure is simple in split-supply applications since this point is ground. In single-supply applications, the medium-bias mode necessitates using a voltage divider as indicated in Figure 1. The use of large-value resistors in the voltage divider reduces the current drain of the divider from the supply line. However, large-value resistors used in conjunction with a large-value capacitor require significant time to charge up to the supply midpoint after the supply is switched on. A voltage other than the midpoint may be used if it is within the voltages specified in the following table. To the Bias-Select Pin 1 M Ω High Medium Low VDD 1 M Ω 0.01 µF BIAS MODE BIAS-SELECT VOLTAGE (single supply) Low Medium High VDD 1 V to VDD –1 V GND Figure 1. Bias Selection for Single-Supply Applications |
|
Link URL |
| Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link to Datasheet | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |