HS-7239 datasheet(13/84 Pages) BOSER

13 / 84 page

Chapter 3

Hardware Installation

This chapter provides the information on how to install the hardware

using the HS-7239/HS-7239M. This chapter also contains information

related to jumper settings of switch, watchdog timer etc.

3.1 Before Installation

After confirming your package contents, you are now ready to install

your hardware. The following are important reminders and steps to

take before you begin with your installation process.

Make sure that all jumper settings match their default settings

and CMOS setup correctly. Refer to the sections on this chapter

for the default settings of each jumper. (Set JP2 1-2)

Go through the connections of all external devices and make

sure that they are installed properly and configured correctly

within the CMOS setup. Refer to the sections on this chapter

for the detailed information on the connectors.

Keep the manual and diskette in good condition for future

reference and use.

NOTE:

Since AD22 has been assigned for ISA bridge at

HS-7239/HS-7239M, please make sure do not use this address for

other PCI cards to avoid confliction. In order to get detailed

information, please contact technical support engineer.

HS-7239 Datasheet(PDF) 13 Page - BOSER Technology Co., Ltd