ATmega16A datasheet(121/352 Pages) ATMEL

121 / 352 page

121

8154B–AVR–07/09

ATmega16A

The setup of the OC2 should be performed before setting the Data Direction Register for the port

pin to output. The easiest way of setting the OC2 value is to use the Force Output Compare

(FOC2) strobe bit in Normal mode. The OC2 Register keeps its value even when changing

between Waveform Generation modes.

Be aware that the COM21:0 bits are not double buffered together with the compare value.

Changing the COM21:0 bits will take effect immediately.

17.6

Compare Match Output Unit

The Compare Output mode (COM21:0) bits have two functions. The Waveform Generator uses

the COM21:0 bits for defining the Output Compare (OC2) state at the next compare match. Also,

the COM21:0 bits control the OC2 pin output source. Figure 17-4 shows a simplified schematic

of the logic affected by the COM21:0 bit setting. The I/O Registers, I/O bits, and I/O pins in the

figure are shown in bold. Only the parts of the general I/O Port Control Registers (DDR and

PORT) that are affected by the COM21:0 bits are shown. When referring to the OC2 state, the

reference is for the internal OC2 Register, not the OC2 pin.

Figure 17-4. Compare Match Output Unit, Schematic

The general I/O port function is overridden by the Output Compare (OC2) from the waveform

generator if either of the COM21:0 bits are set. However, the OC2 pin direction (input or output)

is still controlled by the Data Direction Register (DDR) for the port pin. The Data Direction Regis-

ter bit for the OC2 pin (DDR_OC2) must be set as output before the OC2 value is visible on the

pin. The port override function is independent of the Waveform Generation mode.

The design of the output compare pin logic allows initialization of the OC2 state before the out-

put is enabled. Note that some COM21:0 bit settings are reserved for certain modes of

operation. See “Register Description” on page 130.

17.6.1

Compare Output Mode and Waveform Generation

The waveform generator uses the COM21:0 bits differently in Normal, CTC, and PWM modes.

For all modes, setting the COM21:0 = 0 tells the Waveform Generator that no action on the OC2

PWM modes refer to Table 17-3 on page 131. For fast PWM mode, refer to Table 17-4 on page

132, and for phase correct PWM refer to Table 17-5 on page 132.

PORT

DDR

OCn

Waveform

Generator

COMn1

COMn0

FOCn

clk

I/O

ATmega16A Datasheet(PDF) 121 Page - ATMEL Corporation

ATmega16A Datasheet(HTML) 121 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL