73S8014RT-ILSLASHF datasheet(19/29 Pages) TERIDIAN

Part #	73S8014RT-IL/F

Description	Smart Card Interface

PDF	29 Pages

Scroll/Zoom	100%

Manufacturer	TERIDIAN [Teridian Semiconductor Corporation]

Direct Link	http://www.teridian.com

Logo

19 / 29 page

DS_8014RT_015

73S8014RT Data Sheet

Rev. 1.0

3.7

Deactivation Sequence

Deactivation is initiated either by the system controller by setting CMDVCC% and CMDVCC# high, or automatically

in the event of hardware faults. Hardware faults are over-current, VDD fault, VCC fault, and card extraction during the

session.

The following steps show the deactivation sequence and the timing of the card control signals when the system

controller sets CMDVCC% and CMDVCC# high or OFF goes low due to a fault or card removal:

RST goes low at the end of t1.

CLK is set low at the end of t2.

I/O goes low at the end of t3. Out of reception mode.

VCC is shut down at the end of time t4. After a delay t5 (discharge of the VCC capacitor), VCC is low.

t1 = > 0.5μs, timing by 1.5MHz internal Oscillator

t2 = > 7.5μs

t3 = > 0.5μs

t4 = > 0.5μs

t5 = depends on VCC filter capacitor.

Figure 6: Deactivation Sequence

73S8014RT-IL/F Datasheet(PDF) 19 Page - Teridian Semiconductor Corporation