CS4294SLASHCS4298 datasheet(76/81 Pages) CIRRUS

76 / 81 page

CS4205

DS489PP4

These pins provide the supply voltage and ground for the clocking section of the CS4205. In XTAL or

OSC clocking modes DVdd1 should be tied to +5 VD or to +3.3 VD, with DVss1 tied to DGND. In PLL

clocking mode, DVdd1 must be tied to +5 VA and DVss1 must be tied to AGND. If connecting these

pins to +5 VD or to +3.3 VD and DGND, the CS4205 and controller AC-link should share a common

digital supply.

DVdd2, DVss2 - Digital Supply Voltage 2 / Digital Ground 2, Pins 9 and 7

These pins provide the digital supply voltage and digital ground for the AC-link section of the CS4205.

In all clocking modes DVdd2 should be tied to +5 VD or to +3.3 VD, with DVss2 tied to DGND. The

CS4205 and controller AC-link should share a common digital supply. DVss2 should be isolated from

analog ground currents.

AVdd1, AVss1 - Analog Supply Voltage 1 / Analog Ground 1, Pins 25 and 26

These pins provide the analog supply voltage and analog ground for the analog and mixed signal

sections of the CS4205. AVdd1 must be tied to the +5 VA power supply, with AVss1 connected to

AGND. It is strongly recommended the +5 VA power supply be generated from a voltage regulator to

ensure proper supply currents and noise immunity from the rest of the system. AVss2 should be isolated

from digital ground currents

AVdd2, AVss2 - Analog Supply Voltage 2 / Analog Ground 2, Pins 38 and 42

The AVdd2 and AVss2 pins are not used on the CS4205 and may be left floating or tied to +5 VA and

AGND for backwards compatibility

CS4294/CS4298 Datasheet(PDF) 76 Page - Cirrus Logic