SA9102C

6/12

sames

3.

Electrostatic Discharge (ESD) Protection

The SA9102C integrated circuit's inputs/outputs are protected against ESD according

to Mil-Std 883C, method 3015.

4.

Power Consumption

The power consumption rating of the SA9102C integrated circuit is less than 50mW.

TYPICAL APPLICATIONS

In the Application Circuits (Figures 1 and 2) the components required for power metering

applications, are shown.

In Figure 1 a shunt resistor is used for current sensing. In this application, the circuit

requires a +2.5V, 0V, -2.5V DC supply.

In the case of Figure 2, when using a current transformer for current sensing, a +5V, 0V

DC supply is sufficient.

The most important external components for the SA9102C integrated circuit are:

C

converters. The value of these capacitors is 560pF.

The actual values determine the signal to noise and stability performance. The tolerances

should be within ±10%.

C

The optimum value is

3.3nF. The actual values are uncritical. Values smaller than 0.5nF and larger than 5nF

should be avoided.

R

The values should be selected for an input current of 16µA into the SA9102C at maximum

line current.

Values for RSH of less than 200µ

Ω should be avoided.

R

Where

I

L

=

Line current

RSH

=

Shunt resistor/termination resistor

R

so that the input current into the voltage sense input (virtual ground) is set to 14µA.

R

are set. R

Any change to R

affect the output quadratically (i.e.: R