DSPIC30F2010 datasheet(93/202 Pages) MICROCHIP

93 / 202 page

DS70118J-page 93

dsPIC30F2010

15.3

Slave Select Synchronization

The SSx pin allows a Synchronous Slave mode. The

SPI must be configured in SPI Slave mode, with SSx

pin control enabled (SSEN = 1). When the SSx pin is

low, transmission and reception are enabled, and the

SDOx pin is driven. When SSx pin goes high, the SDOx

pin is no longer driven. Also, the SPI module is re-

synchronized, and all counters/control circuitry are

reset. Therefore, when the SSx pin is asserted low

again, transmission/reception will begin at the MSb,

even if SSx had been de-asserted in the middle of a

transmit/receive.

15.4

SPI Operation During CPU Sleep

Mode

During Sleep mode, the SPI module is shut down. If

the CPU enters Sleep mode while an SPI transaction

is in progress, then the transmission and reception is

aborted.

The transmitter and receiver will stop in Sleep mode.

However, register contents are not affected by

entering or exiting Sleep mode.

15.5

SPI Operation During CPU Idle

Mode

When the device enters Idle mode, all clock sources

remain functional. The SPISIDL bit (SPIxSTAT<13>)

selects if the SPI module will stop or continue on Idle.

If SPISIDL = 0, the module will continue to operate

when the CPU enters Idle mode. If SPISIDL = 1, the

module will stop when the CPU enters Idle mode.

DSPIC30F2010 Datasheet(PDF) 93 Page - Microchip Technology