705-5100-110 datasheet(4/68 Pages) MAGNETROL

4 / 68 page

1.0

QuickStart Installation

The QuickStart Installation procedures provide the key

steps for mounting, wiring, and configuring the Eclipse

level transmitter. These procedures are intended for experi-

enced installers of electronic level measurement instruments.

See Complete Installation, Section 2.0, for detailed installa-

tion instructions.

WARNING: The Model 7xD, 7xG, 7xR or 7xT overfill probes should

be used for Safety Shutdown/Overfill applications. All

other Guided Wave Radar probes should be installed so

the maximum overfill level is a minimum of 6" (150 mm)

below the process connection. This may include utilizing

a nozzle or spool piece to raise the probe. Consult fac-

tory to ensure proper installation.

1.1

Getting Started

Before beginning the QuickStart Installation procedures,

have the proper equipment, tools, and information available.

1.1.1 Equipment and Tools

• Open-end wrenches or adjustable wrench to fit the

process connection size and type. Coaxial probe 11⁄2"

(38 mm), twin rod probe 17⁄8" (47 mm), transmitter

11⁄2" (38 mm). A torque wrench is highly desirable.

• Flat-blade screwdriver

• Cable cutter and 3⁄32" (2.5 mm) hex wrench

(Flexible probes only)

• Digital multimeter or digital volt/ammeter

• 24 VDC power supply, 23 mA minimum

57-600 Eclipse Guided Wave Radar Transmitter

705-5100-110 Datasheet(PDF) 4 Page - Magnetrol International, Inc.