EPC131 datasheet(5/9 Pages) EPC

5 / 9 page

epc130/epc131

Functional Description

Power-up Sequence

If VDD reaches VPOR, the startup sequence is initiated. After the time tDEL, the photo diode bias circuit is enabled. Thus, a current generated by

light on the photo diode flows into the pin PD. After the time tINIT, the device is ready to receive AC light pulses.

Power-up sequence

Power-down Sequence

When VDD goes down, the device is turned off when V DD is below VPOR minus VIPOR.

Power-down sequence

Light Pulse Reception

A light pulse on the photo diode generates a current puls into the pin PD of the device. This current pulse is transformed to a voltage pulse

and amplified. The signal form is dependent on the input pulse width, its slew rate and its strength. The value of the undershoot is als heavily

dependent on the input signal. If the input signal is too strong, the output signal becomes saturated close to V DD, or VSS respectively.

After a waiting time given by tREC, the next light pulse can be sent. If the waiting time is too short, the output signal of the next pulse is biased.

Light pulse reception

Characteristics subject to change without notice

Datasheet epc13x analog - V2.1

www.espros.ch

POR

INIT

Startup

Period

Ready

Out

undefined output signal

POR -

IPOR

OFF

PD bias

IR LED Pulse

IR LED

PD Signal

Out Signal

REC

EPC131 Datasheet(PDF) 5 Page - Espros Photonics corp

EPC131 Datasheet(HTML) 5 Page - Espros Photonics corp

Html Pages

1 2 3 4 5 6 7 8 9

Datasheet Download

Link URL