TL3016, TL3016Y

ULTRA-FAST LOW-POWER

PRECISION COMPARATORS

SLCS130D – MARCH 1997 – REVISED MARCH 2000

5

POST OFFICE BOX 655303

PARAMETER

TEST CONDITIONS†

TL3016C

TL3016I

UNIT

PARAMETER

TEST CONDITIONS†

MIN

TYP

MAX

MIN

TYP

MAX

UNIT

‡

∆VI = 100 mV, TA = 25°C

7.8

10

7.8

10

t d1

Propagation dela time‡

I

,

VOD = 5 mV

TA = full range

7.8

11.2

7.8

12.2

ns

tpd1

Propagation delay time‡

∆VI = 100 mV, TA = 25°C

7.6

10

7.6

10

ns

I

,

VOD = 20 mV

TA = full range

7.6

11.2

7.6

12.2

tsk(p)

Pulse skew (|tpd+ – tpd–|)

∆VI = 100 mV,

TA = 25°C

VOD = 5 mV,

0.5

0.5

ns

tsu

Setup time, LATCH ENABLE

2.5

2.5

ns

† Full range for the TL3016C is 0

°C to 70°C. Full range for the TL3016I is –40°C to 85°C.

‡ tpd1 cannot be measured in automatic handling equipment with low values of overdrive. The TL3016 is 100% tested with a 1-V step and 500-mV

overdrive at TA = 25°C only. Correlation tests have shown that tpd1 limits given can be ensured with this test, if additional dc tests are performed

to ensure that all internal bias conditions are correct. For low overdrive conditions, VOS is added to the overdrive.

TYPICAL CHARACTERISTICS

Table of Graphs

FIGURE

vs Input voltage

2

ICC

Positive supply current

vs Frequency

3

vs Free-air temperature

4

ICC

Negative supply current

vs Free-air temperature

5

vs Overdrive voltage

6

vs Supply voltage

7

tpd

Propagation delay time

vs Input impedance

8

vs Load capacitance

9

vs Free-air temperature

10

VIC

Common-mode input voltage

vs Free-air temperature

11

Input threshold voltage (LATCH ENABLE)

vs Free-air temperature

12

VO

Output voltage

vs Output source current

13

VO

Output voltage

vs Output sink current

14

II

Input current (LATCH ENABLE)

vs Input voltage

15