 2001-2012 Microchip Technology Inc.

DS21479D-page 13

TC850

TABLE 6-1:

BUS INTERFACE TRUTH TABLE

CE • CS

Pins 1 and 2

RD

Pin 4

CONT/DEMAND

Pin 5

L/H

Pin 7

OVR/POL

Pin 6

DB7

Pin 8

DB6–DB0

Pin 9-Pin 15 (Note 1)

00

0

0

0

“1” = Input Positive

Data Bits 14 - 8

00

0

0

1

“1” = Input Overrange

(Note 2)

Data Bits 14 - 8

00

0

1

X

Data Bit 7

Data Bits 6 - 0

00

1

X

X

Note 3

01

X

X

X

High-Impedance State

1X

X

X

X

High-Impedance State

Note

1: Pin numbers refer to 40-pin PDIP.

2: Extended overrange operation: Although rated at 15 bits (±32,767 counts) of resolution, the TC850 provides an addi-

tional 191 counts above full scale. For example, with a full-scale input of 3.2768V, the maximum analog input voltage

which will be properly converted is 3.2958V. The extended resolution is signified by the overrange bit being high and the

low-order byte contents being between 0 and 190. For example, with a full-scale voltage of 3.2768V:

Overrange Bit

Low Byte

Data Bits 14–8

3.2767V

Low

3.2768V

High

3.2769V

High

3.2867V

High

3: Continuous mode data transfer:

a. In Continuous mode, data MUST be read in three sequential bytes after the BUSY output goes low:

(1) The first byte read will be the high-order byte, with DB7 = polarity.

(2) The second byte read will contain the low-order byte.

(3) The third byte read will again be the high-order byte, but with DB7 = overrange.

b. All three data bytes must be read within 443-1/2 clock cycles after the falling edge of BUSY.

c.

The c input must go high after each byte is read, so that the internal byte counter will be incremented.

However, the CS and CEinputs can remain enabled through the entire data transfer sequence.