DEMO9S08MP16 datasheet(21/37 Pages) FREESCALE

21 / 37 page

DEMO9S08MP16 User Manual

paused and the scale of the X and Y axes can be changed via a tool bar

located in the top right corner of the Serial Grapher Application.

All data to be displayed must be in hexadecimal format. The data can be

accepted and displayed either as incoming byte values ($00-$FF) or word

values ($0000-$FFFF). The data format indicates whether the data is byte or

word data. The graphical components automatically size their range

depending upon the incoming data.

This PC-based application is included on the DVD-ROM that accompanies

the DEMO9S08MP16 and may also be found at:

http://www.pemicro.com/fixedlinks/demotoolkit.cfm.

6.4.1

Visual Components

The Bar Graph has four separate bars A, B, C, and D. On each bar a

percentage value is displayed which indicates the current value relative to the

full range. A byte value of $7F (max is $FF) would show up as approximately

50% as would a word value of $7FFF (max is $FFFF). As can be seen in the

data formatting section, all four bars must be written at the same time. The

bars are shown here:

DEMO9S08MP16 Datasheet(PDF) 21 Page - Freescale Semiconductor, Inc