AS5161

Datasheet - Detailed Descr i p ti on

www.ams.com

Revision 1.1

9 - 35

8 Detailed Description

The AS5161 is manufactured in a CMOS process and uses a spinning current Hall technology for sensing the magnetic field distribution across

the surface of the chip.

The integrated Hall elements are placed around the center of the device and deliver a voltage representation of the magnetic field at the surface

of the IC.

Through Sigma-Delta Analog / Digital Conversion and Digital Signal-Processing (DSP) algorithms, the AS5161 provides accurate high-resolution

absolute angular position information. For this purpose a Coordinate Rotation Digital Computer (CORDIC) calculates the angle and the

magnitude of the Hall array signals.

The DSP is also used to provide digital information at the outputs that indicate movements of the used magnet towards or away from the device’s

surface.

A small low cost diametrically magnetized (two-pole) standard magnet provides the angular position information.

The AS5161 senses the orientation of the magnetic field and calculates a 14-bit binary code. This code is mapped to a programmable output

characteristic in a PWM duty cycle format. This signal is available at the pin (OUT).

The application angular region can be programmed in a user friendly way. The start angle position T1 and the end point T2 can be set and

programmed according the mechanical range of the application with a resolution of 14 bits. In addition the T1Y and T2Y parameter can be set

and programmed according the application. The transition point 0 to 360 degree can be shifted using the break point parameter BP. The voltage

for clamping level low CLL and clamping level high CLH can be programmed with a resolution of 9 bits. Both levels are individually adjustable.

Two additional linearization points can be used to improve the system linearity. These points C1 and C2 are programmable.

The output parameters can be programmed in an OTP register. No additional voltage is required to program the AS5161. The setting may be

overwritten at any time and will be reset to default when power is cycled. To make the setting permanent, the OTP register must be programmed

by using a lock bit the content could be frozen for ever.

The AS5161 is tolerant to magnet misalignment and unwanted external magnetic fields due to differential measurement technique and Hall

sensor conditioning circuitry.

8.1 Operation

8.1.1 VDD Voltage Monitor

time the output is turned off. When the over voltage event has passed and the voltage applied to pin VDD falls below the over-voltage lower

threshold for longer than the recovery time the device enters the normal mode and the output is enabled.

the detection time the output is turned off. When the voltage applied to the VDD pin exceeds the under-voltage upper threshold for longer than

the detection time the device enters the normal mode and the output is enabled.