JKXFD1G05MCSM datasheet(8/10 Pages) ETC2

8 / 10 page

JKX Series

• Connector preparation

1 - Select the proper collet ➃ and the cable

seal ➂ (see page 39).

2 - Slide protective boot ➅, the backnut ➄, the

collet ➃, the cable seal ➂, the outershell ➁

and the taper seat ➀ onto the cable. Strip end

of cable (see pg. 16)

• Contacts wiring : crimp contacts

1 - Select the proper crimping tool (see page 48)

2 - Adjust the crimping tool based on the wire

size “AWG”. (See wire size and crimp tool

settings on the back of this locator.)

3 - Crimp the contacts ➃ then insert the contact

into the insulator until the clip is fully seated

and cannot be removed.

• Contacts wiring : solder contacts

Fixed solder contacts 0.5 mm and 0.7 mm

Removable solder contacts from 0.9 mm to 1.3 mm

1 - Insert wire into solder cup and solder

2 - Insert the contact into the insulator until the clip is fully seated and cannot be removed.

• Connector assembly

1 - In case of shielded cable, comb out the shield

and fold back over the tapper seat ➀.

2 - Position 2 half bushes ➈, making sure that the

insert key appears through the windows of one

bush.

3 - Position the taper seat ➀ on the half bushes ➈.

4 - Position all the sub-assembly in connector

housing ➉, making sure to keep the sub-

assembly well aligned.

5 - Screw the outershell ➁ following the torque

values on page 39. Install the cable seal ➂ and

the collet ➃ into the outershell ➁ then screw

the backnut ➄ till bottoming. Use 2 wrenches

well positionned on the flats A and B. Place a

wrench to grip flats B, use the other wrench to

tighten the backnut at the flats A following the

torque values on page 39.

6 - Install the protective boot ➅ if applicable.

Wiring and assembly

instructions :

STRAIGHT PLUG

• Cable stripping : see page 37

JKXFD1G05MCSM Datasheet(PDF) 8 Page - List of Unclassifed Manufacturers

JKXFD1G05MCSM Datasheet(HTML) 8 Page - List of Unclassifed Manufacturers

Html Pages

1 2 3 4 5 6 7 8 9 10

Datasheet Download

Link URL