UM1038

STM32 (STEVAL-PCC012V1) and EVALST7590-1

Doc ID 18303 Rev 1

7/24

3

STM32 (STEVAL-PCC012V1) and EVALST7590-1

The demonstration boards necessary to connect the STM32 and ST7590 boards and their

configuration:

1.

STEVAL-PCC012V1

●

Flash the correct firmware into STM32.

●

Configure the board according to Figure 3.

2.

EVALST7590-1

●

Put the jumper into position JP12 - USB_RES (see paragraph 1

in Appendix C).

●

Configure the board according to Figure 7.

●

Interconnect EVALST7590-1 according to Table 2 and Figure 9.

Figure 6.

EVALST7590 - microcontroller extension connector

Figure 7.

EVALST7590 - jumper setup

Figure 8.

STEVAL-PCC012V1 - PLM connector CN7