UM0900 datasheet(38/43 Pages) STMICROELECTRONICS

38 / 43 page

Ordering information

UM0900

38/43

Doc ID 17028 Rev 1

Ordering information

The demonstration board is available through the standard ordering system, the order code

is: STEVAL-IHM025V1. The items delivered include the assembled application board, board

documentation, PCB fabrication data such as gerber files, assembly files (pick and place)

and component documentation.

Using the STEVAL-IHM025V1 with STM32 FOC

firmware library

STM32 FOC firmware library v2.0 is a firmware library running on the STM3210B-MCKIT

which allows the performing of the FOC of a PMSM in configuration with and without

sensors.

This section describes the modifications to be applied to the STM32 FOC firmware library

v2.0 in order to make the firmware compatible with the STEVAL-IHM025V1.

10.1

Environmental considerations

Warning:

The STEVAL-IHM025V1 demonstration board must only be

used in a power laboratory. The voltage used in the drive

system presents a shock hazard.

The kit is not electrically isolated from the DC input. This topology is very common in motor

drives. The microprocessor is grounded by the integrated ground of the DC bus. The

microprocessor and associated circuitry are hot and MUST be isolated from user controls

and communication interfaces.

Warning:

All measuring equipment must be isolated from the main

power supply before powering up the motor drive. To use an

oscilloscope with the kit, it is safer to isolate the DC supply

AND the oscilloscope. This prevents shock occurring as

a result of touching any SINGLE point in the circuit, but does

NOT prevent shock when touching two or more points in the

circuit.

UM0900 Datasheet(PDF) 38 Page - STMicroelectronics