PR01, PR02, PR03

www.vishay.com

Vishay BCcomponents

Revision: 10-Sep-15

4

Document Number: 28729

THIS DOCUMENT IS SUBJECT TO CHANGE WITHOUT NOTICE. THE PRODUCTS DESCRIBED HEREIN AND THIS DOCUMENT

DESCRIPTION

A homogeneous film of metal alloy is deposited on a high

grade ceramic body. After a helical groove has been cut in

the resistive layer, tinned connecting wires of electrolytic

copper or copper-clad iron are welded to the end-caps. The

resistors are coated with a red, non-flammable lacquer

conformal coating which provides electrical, mechanical

and climatic protection. This coating is not resistant to

aggressive fluxes and cleaning solvents. The conformal

coating is resistant to all cleaning solvents in accordance

with IEC 60068-2-45.

ASSEMBLY

list of legal restrictions on hazardous substances. This

includes full compliance with the following directives:

• 2000/53/EC End of Life Vehicle Directive (ELV) and

Annex II (ELV II)

• 2011/65/EU

Restriction

of

the

use

of

Hazardous

Substances Directive (RoHS)

• 2012/19/EU Waste Electrical and Electronic Equipment

Directive (WEEE)

Material categorization: for definitions of compliance please

MATERIALS

Vishay acknowledges the following systems for the

regulation of hazardous substances:

• IEC 62474, Material Declaration for Products of and for the

Electrotechnical Industry, with the list of declarable

• The

Global

Automotive

Declarable

Substance

List

• The REACH regulation (1907/2006/EC) and the related list

supply chain

The products do not contain any of the banned substances

as per IEC 62474, GADSL, or the SVHC list, see



Hence the products fully comply with the following

directives:

• 2000/53/EC End-of-Life Vehicle Directive (ELV) and

Annex II (ELV II)

• 2011/65/EU

Restriction

of

the

Use

of

Hazardous

Substances

Directive

(RoHS)

with

amendment

2015/863/EU

• 2012/19/EU Waste Electrical and Electronic Equipment

Directive (WEEE)

Vishay pursues the elimination of conflict minerals from its

supply

chain,

see

the

Conflict

Minerals

Policy

at

APPROVALS

The resistors PR01 and PR02 are approved within the

AEC-Q200 Quality Assessment System for Electronic

Components.

Essentially all tests are carried out in accordance with

IEC 60115-1 specification, category -55 °C / +200 °C /

56

days

(rated

temperature

range:

lower

category

temperature, upper category temperature; damp heat, long

term, 56 days). The tests are carried out in accordance with

IEC 60068-2-xx.

Test method under standard atmospheric conditions

according to IEC 60068-1, 5.3.

In the Test Procedures and Requirements table, tests and

requirements are listed with reference to the relevant

clauses of IEC 60115-1 and IEC 60068-2-xx test methods.

A short description of the test procedure is also given. In

some instances deviations from the IEC recommendations

were necessary for our method of specifying.

All soldering tests are performed with non activated flux.

RELATED PRODUCTS

For more information on products with higher wattage,

higher pulse load capability and metal oxide film technology,

please refer to the WK/WR datasheet at the link:

www.vishay.com/doc?20128

Notes

www.gadsl.org

organisation

representing

the

information

and

communications

technology

and

consumer

electronics),

see



All products comply with the IEC 62474, Material Declaration for Products of and for the Electrotechnical Industry.