AP7176B datasheet(10/14 Pages) DIODES

10 / 14 page

AP7176B

Document number: DS35818 Rev.3 - 2

10 of 14

www.diodes.com

April 2014

AP7176B

Application Information (cont.)

Output Capacitor

An output capacitor (COUT) is needed to improve transient response and maintain stability. The ESR (equivalent series resistance) and

capacitance drives the selection. Care needs to be taken to cover the entire operating temperature range.

The output capacitor can be an Ultra-Low-ESR ceramic chip capacitor or a low ESR bulk capacitor like a solid tantalum, POSCap or aluminum

electrolytic capacitor.

COUT is used to improve the output stability and reduces the changes of the output voltage during load transitions. The slew rate of the current

sensed via the FB pin in AP7176B is reduced. If the application has large load variations, it is recommended to utilize low-ESR bulk capacitors.

It is recommended to place ceramic capacitors as close as possible to the load and the ground pin and care should be taken to reduce the

impedance in the layout.

Input Capacitor

To prevent the input voltage from dropping during load steps it is recommended to utilize an input capacitor (CIN). As with the output capacitor

the following are acceptable, Ultra-Low-ESR ceramic chip capacitor or low ESR bulk capacitor like a solid tantalum, POSCap or aluminum

electrolytic capacitor. Typically it is recommended to utilize an capacitance of at least 10µF to avoid output voltage drop due to reduced input

voltage. The value can be lower if VIN changes are not critical for the application.

Layout Consideration

For good ground loop and stability, the input and output capacitors should be located close to the input, output, and ground pins of the device.

No other application circuit is connected within the loop. Avoid using vias within ground loop. If vias must be used, multiple vias should be used

to reduce via inductance.

The regulator ground pin should be connected to the external circuit ground to reduce voltage drop caused by trace impedance. Ground plane is

generally used to reduce trace impedance.

Wide trace should be used for large current paths from VIN to VOUT, and load circuit.

Place the R1, R2, and C1 (optional) near the LDO as close as possible to avoid noise coupling.

R2 is placed close to device ground. Connect the ground of the R2 to the GND pin by using a dedicated trace.

Connect the pin of the R1 directly to the load for Kelvin sensing.

No high current should flow through the ground trace of feedback loop and affect reference voltage stability.

For the packages with exposed pads, heat sinking is accomplished using the heat spreading capability of the PCB and its copper traces.

Suitable PCB area on the top layer and thermal vias (0.3mm drill size with 1mm spacing, 4 to 8 vias at least) to the VIN power plane can help to

reduce device temperature greatly.

Reference Layout Plots:

Top Layer

Bottom Layer

GND

Vcntl

Vout

Cin

Cout

Ccntl

Vin

Vcntl

GND

AP7176B Datasheet(PDF) 10 Page - Diodes Incorporated

AP7176B Datasheet(HTML) 10 Page - Diodes Incorporated

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Datasheet Download

Link URL