L6599AF datasheet(3/32 Pages) STMICROELECTRONICS

3 / 32 page

DocID028175 Rev 3

3/32

L6599AF

Description

The L6599AF is an improved revision of the previous L6599A. It is a double-ended

controller specific to series-resonant half bridge topology. It provides 50% complementary

duty cycle: the high-side switch and the low-side switch are driven ON/OFF 180° out-of-

phase for exactly the same time. Output voltage regulation is obtained by modulating the

operating frequency. A fixed deadtime inserted between the turn-off of one switch and the

turn-on of the other guarantees soft-switching and enables high-frequency operation.

To drive the high-side switch with the bootstrap approach, the IC incorporates a high voltage

floating structure able to withstand more than 600 V with a synchronous-driven high voltage

DMOS that replaces the external fast-recovery bootstrap diode.

The IC enables the designer to set the operating frequency range of the converter by means

of an externally programmable oscillator.

At startup, to prevent uncontrolled inrush current, the switching frequency starts from a

programmable maximum value and progressively decays until it reaches the steady-state

value determined by the control loop. This frequency shift is non-linear to minimize output

voltage overshoots; its duration is programmable as well.

At light load the IC may enter a controlled burst mode operation that keeps the converter

input consumption to a minimum.

IC functions include a not-latched active-low disable input with current hysteresis useful for

power sequencing or for brownout protection, a current sense input for OCP with frequency

shift and delayed shutdown with automatic restart. A higher level OCP latches off the IC if

the first-level protection is not sufficient to control the primary current. Their combination

offers complete protection against overload and short-circuits. An additional latched disable

input (DIS) allows easy implementation of OTP and/or OVP.

An interface with the PFC controller is provided that enables the pre-regulator to be

switched off during fault conditions, such as OCP shutdown and DIS high, or during burst

mode operation.

L6599AF Datasheet(PDF) 3 Page - STMicroelectronics