M24C02-DRMF3TP datasheet(18/39 Pages) STMICROELECTRONICS

18 / 39 page

Instructions

M24C02-A125

18/39

DocID025755 Rev 4

4.1.3

Write Identification Page

The Identification Page (16 bytes) is an additional page which can be written and (later)

permanently locked in Read-only mode. It is written by issuing the Write Identification Page

instruction. This instruction uses the same protocol and format as Page Write (into memory

array), except for the following differences:

•

Device type identifier = 1011b

•

Most significant address bits A7/A4 are don't care, except for address bit A7 which

must be “0”. Least significant address bits A3/A0 define the byte location inside the

Identification page.

If the Identification page is locked, the data bytes transferred during the Write Identification

Page instruction are not acknowledged (NoAck).

4.1.4

Lock Identification Page

The Lock Identification Page instruction (Lock ID) permanently locks the Identification page

in Read-only mode. The Lock ID instruction is similar to Byte Write (into memory array) with

the following specific conditions:

•

Device type identifier = 1011b

•

Address bit A7 must be ‘1’; all other address bits are don't care

•

The data byte must be equal to the binary value xxxx xx1x, where x is don't care

M24C02-DRMF3TP Datasheet(PDF) 18 Page - STMicroelectronics