LP8545 datasheet(18/44 Pages) TI1

18 / 44 page

Brightness (PWM)

Time

Slope Time

Advanced slope

Brightness (PWM)

Sloper Input

PWM Output

Time

Normal slope

Steady state without dithering

If dither is enabled it will

be used during transition

to enable smooth effect

OUT1

OUT2

OUT3

OUT4

OUT5

OUT6

tSHIFT = 1/(FPWM x 6)

Shift time

1/(FPWM)

Cycle time

LP8545

SNVS635D – APRIL 2010 – REVISED DECEMBER 2013

www.ti.com

Figure 14. Phase Shift PWM Mode

Slope and Dithering

During transition between two brightness (PWM) values special dithering scheme is used if the slope is enabled.

It allows increased resolution and smaller average steps size. Dithering is not used in steady state condition.

Slope time can be programmed with EEPROM bits <SLOPE[3:0]> from 0 to 500 ms. Same slope time is used for

sloping up and down. Advanced slope makes brightness changes smooth for eye. Dithering can be programmed

with EEPROM bits <DITHER[1:0]> from 0 to 3 bits. Example below is for 1-bit dithering, e.g., for 3-bit dithering,

every 8th pulse is made 1 LSB longer to increase the average value by 1/8 of LSB.

Figure 15. Sloper Operation

Submit Documentation Feedback

Product Folder Links: LP8545

LP8545 Datasheet(PDF) 18 Page - Texas Instruments