P89LPC932BA datasheet(20/60 Pages) PHILIPS

20 / 60 page

Philips Semiconductors

P89LPC932

8-bit microcontroller with accelerated two-clock 80C51 core

Product data

Rev. 04 — 06 January 2004

20 of 60

9397 750 12379

The P89LPC932 also has 512 bytes of on-chip Data EEPROM that is accessed via

SFRs (see Section 8.26 “Data EEPROM”).

8.10 Data RAM arrangement

The 768 bytes of on-chip RAM are organized as shown in Table 5.

8.11 Interrupts

The P89LPC932 uses a four priority level interrupt structure. This allows great

ﬂexibility in controlling the handling of the many interrupt sources. The P89LPC932

supports 15 interrupt sources: external interrupts 0 and 1, timers 0 and 1, serial port

Tx, serial port Rx, combined serial port Rx/Tx, brownout detect, watchdog/Real-Time

clock, I2C, keyboard, comparators 1 and 2, SPI, CCU, data EEPROM write

completion.

Each interrupt source can be individually enabled or disabled by setting or clearing a

bit in the interrupt enable registers IEN0 or IEN1. The IEN0 register also contains a

global disable bit, EA, which disables all interrupts.

Each interrupt source can be individually programmed to one of four priority levels by

setting or clearing bits in the interrupt priority registers IP0, IP0H, IP1, and IP1H. An

interrupt service routine in progress can be interrupted by a higher priority interrupt,

but not by another interrupt of the same or lower priority. The highest priority interrupt

service cannot be interrupted by any other interrupt source. If two requests of

different priority levels are pending at the start of an instruction, the request of higher

priority level is serviced.

If requests of the same priority level are pending at the start of an instruction, an

internal polling sequence determines which request is serviced. This is called the

arbitration ranking. Note that the arbitration ranking is only used to resolve pending

requests of the same priority level.

8.11.1

External interrupt inputs

The P89LPC932 has two external interrupt inputs as well as the Keypad Interrupt

function. The two interrupt inputs are identical to those present on the standard

80C51 microcontrollers.

These external interrupts can be programmed to be level-triggered or edge-triggered

by setting or clearing bit IT1 or IT0 in Register TCON.

In edge-triggered mode, if successive samples of the INTn pin show a HIGH in one

cycle and a LOW in the next cycle, the interrupt request ﬂag IEn in TCON is set,

causing an interrupt request.

Table 5:

On-chip data memory usages

Type

Data RAM

Size (bytes)

DATA

Memory that can be addressed directly and indirectly

128

IDATA

Memory that can be addressed indirectly

256

XDATA

Auxiliary (‘External Data’) on-chip memory that is accessed

using the MOVX instructions

512

P89LPC932BA Datasheet(PDF) 20 Page - NXP Semiconductors

P89LPC932BA Datasheet(HTML) 20 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60

Datasheet Download

Link URL