3

®

INA156

PIN CONFIGURATION

ELECTROSTATIC

DISCHARGE SENSITIVITY

This integrated circuit can be damaged by ESD. Burr-Brown

recommends that all integrated circuits be handled with

appropriate precautions. Failure to observe proper handling

and installation procedures can cause damage.

ESD damage can range from subtle performance degradation

to complete device failure. Precision integrated circuits may

be more susceptible to damage because very small parametric

changes could cause the device not to meet its published

specifications.

The information provided herein is believed to be reliable; however, BURR-BROWN assumes no responsibility for inaccuracies or omissions. BURR-BROWN assumes

no responsibility for the use of this information, and all use of such information shall be entirely at the user’s own risk. Prices and specifications are subject to change

without notice. No patent rights or licenses to any of the circuits described herein are implied or granted to any third party. BURR-BROWN does not authorize or warrant

any BURR-BROWN product for use in life support devices and/or systems.

Top View

MSOP

Supply Voltage, V+ to V– ................................................................... 7.5V

Operating Temperature .................................................. –65

°C to +150°C

Storage Temperature ..................................................... –65

°C to +150°C

Junction Temperature .................................................................... +150

°C

Lead Temperature (soldering, 10s) ............................................... +300

°C

NOTES: (1) Stresses above these ratings may cause permanent damage.

Exposure to absolute maximum conditions for extended periods may degrade

device reliability. These are stress ratings only, and functional operation of the

device at these or any other conditions beyond those specified is not implied.

(2) Input terminals are diode-clamped to the power supply rails. Input signals

that can swing more that 0.5V beyond the supply rails should be current limited

to 10mA or less. (3) Short circuit to ground.

PACKAGE

SPECIFIED

DRAWING

TEMPERATURE

PACKAGE

ORDERING

TRANSPORT

PRODUCT

PACKAGE

NUMBER

RANGE

MARKING

MEDIA

INA156 EA

MSOP-8

337

–55

°C to +125°C

A56

INA156EA/250

Tape and Reel

""

"

"

"

INA156EA/2K5

Tape and Reel

NOTE: (1) Models with a slash (/) are available only in Tape and Reel in the quantities indicated (e.g., /2K5 indicates 2500 devices per reel). Ordering 2500 pieces

of “INA156EA/2K5” will get a single 2500-piece Tape and Reel.

PACKAGE/ORDERING INFORMATION

R

G

V

IN

V

IN

V–

R

G

V+

V

OUT

Ref

1

2

3

4

8

7

6

5

INA156

+

–