TLE4961-5M datasheet(14/26 Pages) INFINEON

14 / 26 page

TLE4961-5M

Specification

Data Sheet

Revision 1.0, 2013-07-04

3.3

Operating Range

The following operating conditions must not be exceeded in order to ensure correct operation of the TLE4961-5M.

All parameters specified in the following sections refer to these operating conditions unless otherwise mentioned.

3.4

Electrical and Magnetic Characteristics

Product characteristics involve the spread of values guaranteed within the specified voltage and ambient

temperature range. Typical characteristics are the median of the production and correspond to VDD = 12 V and

TA = 25°C. The below listed specification is valid in combination with the application circuit shown in Figure 3-1

and Figure 3-2

Table 3-3

Operating Conditions Parameters

Parameter

Symbol

Values

Unit

Note / Test Condition

Min.

Typ.

Max.

Supply voltage

VDD

3.0

321)

1) Latch-up test with factor 1.5 is not covered. Please see max ratings also.

Output voltage

-0.3

Junction temperature

-40

170

°C

Output current

025

Magnetic signal input frequency2)

2) For operation at the maximum switching frequency the magnetic input signal must be 1.4 times higher than for static fields.

This is due to the -3dB corner frequency of the internal low-pass filter in the signal path.

fSW

010

kHz

Table 3-4

General Electrical Characteristics

Parameter

Symbol

Values

Unit

Note / Test Condition

Min.

Typ.

Max.

Supply current

1.11.6

2.5mA

Reverse current

ISR

0.05

for VDD = -18 V

Output saturation

voltage

VQSAT

0.2

0.5

IQ = 20 mA

0.24

0.6

IQ = 25 mA

Output leakage

current

IQLEAK

μA

Output current

limitation

IQLIMIT

internally limited & thermal

shutdown

Output fall time1)

1) Not subject to production test, verified by design/characterization.

0.17

0.4

μs1.2 kΩ / 50 pF, see Figure 2-3

Output rise time1)

0.4

0.5

μs1.2 kΩ / 50 pF, see Figure 2-3

Output jitter1)2)

2) Output jitter is the 1σ value of the output switching distribution.

tQJ

0.35

μs

For square wave signal with 1 kHz

Delay time1)3)

3) Systematic delay between magnetic threshold reached and output switching.

μssee Figure 2-3

Power-on time1)4)

4) Time from applying VDD = 3.0 V to the sensor until the output is valid.

tPON

150

μsVDD =3V, B ≤ BRP -0.5 mT or

B ≥ BOP +0.5 mT

Chopper frequency1)

fOSC

350

kHz

TLE4961-5M Datasheet(PDF) 14 Page - Infineon Technologies AG

TLE4961-5M Datasheet(HTML) 14 Page - Infineon Technologies AG

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26

Datasheet Download

Link URL