ML50.100, ML50.109

MiniLine

Mar. 2007 / Rev. 1.0 DS-ML50.100-EN

All parameters are specified at 24V, 2.1A, 230Vac, 25°C ambient and after a 5 minutes run-in time unless otherwise noted.

www.pulspower.com Phone +49 89 9278 0

Germany

10/20

16. EMC

The CE mark indicates conformance with EMC guideline 89/336/EEC, 93/68/EEC and the low-voltage directive (LVD)

73/23/EWG. A detailed EMC Report is available on request.

EMC Immunity

EN 61000-6-2, EN 61000-6-1

Generic standards

Electrostatic discharge

EN 61000-4-2

Contact discharge

Air discharge

8kV

8kV

Criterion A

Criterion A

Electromagnetic RF field

EN 61000-4-3

80MHz-1GHz

10V/m

Criterion A

Fast transients (Burst)

EN 61000-4-4

Input lines

Output lines

4kV

2kV

Criterion A

Criterion A

Surge voltage on input

EN 61000-4-5

L

N

N / L

PE

2kV

4kV

Criterion A

Criterion A

Surge voltage on output

EN 61000-4-5

+

-

+ / -

PE

500V

500V

Criterion A

Criterion A

Conducted disturbance

EN 61000-4-6

0,15-80MHz

10V

Criterion A

Mains voltage dips

EN 61000-4-11

0% of 100Vac

40% of 100Vac

70% of 100Vac

0% of 200Vac

40% of 200Vac

70% of 200Vac

0Vac, 20ms

40Vac, 200ms

70Vac, 500ms

0Vac, 20ms

80Vac, 200ms

140Vac, 500ms

Criterion A

Criterion C

Criterion A

Criterion A

Criterion A

Criterion A

Voltage interruptions

EN 61000-4-11

0Vac, 5000ms

Criterion C

Input voltage swells

PULS internal standard

300Vac, 500ms

Criterion A

Powerful transients

VDE 0160

over entire load

range

750V, 1.3ms

Criterion A

Criterions:

A: Power supply shows normal operation behavior within the defined limits.

C: Temporary loss of function is possible. Power supply might shut-down and restarts by itself. No damages or hazards to the power

supply will occur.

EMC Emission

EN 61000-6-3, EN 61000-6-4

Generic standards

Conducted emission

EN 55011, EN 55022, FCC Part 15, CISPR 11, CISPR 22

Class B, input lines

EN 55022

Class B, output lines

Radiated emission

EN 55011, EN 55022

Class B

Harmonic input current

EN 61000-3-2

Fulfilled

Voltage fluctuations, flicker

EN 61000-3-3

Fulfilled

This device complies with FCC Part 15 rules.

Operation is subjected to the following two conditions: (1) this device may not cause harmful interference, and (2) this

device must accept any interference received, including interference that may cause undesired operation.

Switching frequency

variable, typ. 100kHz, (60-275kHz)

Input voltage and output load dependent