PM6613N datasheet(25/30 Pages) STMICROELECTRONICS

Part #	PM6613N

Description	2 to 4-cell Li-Ion, Li-FePO4 battery charger with SMBus interface, N-channel RBFET and BATFET MOSFET selectors

PDF	30 Pages

Scroll/Zoom	100%

Manufacturer	STMICROELECTRONICS [STMicroelectronics]

Direct Link	http://www.st.com

Logo

25 / 30 page

DocID024974 Rev 3

25/30

PM6613N

The PM6613N registers

•

Bit 2 AOV: ACDIV overvoltage

–

set by hardware when the PM6613N detects an ACDIV pin voltage higher than

2.625 V

–

0: no ACDIV overvoltage detected

–

1: ACDIV overvoltage detected

•

Bit 1 AUV: ACDIV undervoltage

–

set by hardware when the PM6613N detects an ACDIV pin voltage lower than 2 V

–

0: no ACDIV undervoltage detected

–

1: ACDIV undervoltage detected

•

Bit 0 HS: high-side short

–

set by hardware when a short condition is detected between drain and source of

the high-side MOS

–

0: no short detected on high-side MOS

–

1: short detected on high-side MOS

5.3

Charge current register (CHRG_AMP)

Address: 0x14

Reset value: 0x0000

•

Bits 13:6 AMP[13:6]: charge current configuration bits

–

these bits are written by software and fix the amount of current to be delivered

when battery is charging. Values are in mA. The range goes from 64 mA when

AMP[13:6] = 0x0040 to 16320 mA when AMP[13:6] = 0x3FC0. Minimum step is 64

mA.

Table 18. CHRG_AMP 0x14

Reserved

AMP[13:6]

Reserved

PM6613N Datasheet(PDF) 25 Page - STMicroelectronics

PM6613N Datasheet(HTML) 25 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30

Datasheet Download

Link URL