| Electronic Components Datasheet Search |
|
A5975AD Datasheet(PDF) 33 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
A5975AD Datasheet(HTML) 33 Page - STMicroelectronics |
|
33 / 50 page ![]() A5975AD Application information Doc ID 018761 Rev 1 33/50 This can be understood considering the inductor current ripple during the ON and OFF phases: On phase Equation 29 Off phase Equation 30 where VD is the voltage drop across the diode, DCRL is the series resistance of the inductor. In short-circuit conditions VOUT is negligible, so during TOFF the voltage across the inductor is very small, as equal to the voltage drop across parasitic components (typically the DCR of the inductor and the VFW of the free-wheeling diode) while during TON, the voltage applied to the inductor is instead maximized as approximately equal to VIN. So, Equation 29 and 30 in overcurrent conditions can be simplified to: Equation 31 considering TON, which has already been reduced to its minimum. Equation 32 considering that fSW has been already reduced to one third of the nominal. In case a short-circuit at the output is applied, and VIN = 12 V, the inductor current is controlled in most of the applications (see Figure 19). When the application must sustain the short-circuit condition for an extended period, the external components (mainly the inductor and diode) must be selected based on this value. In case the VIN is very high, it could occur that the ripple current during TOFF (Equation 32) does not compensate the current increase during TON (Equation 31). Figure 21 shows an example of a power-up phase with VIN = VIN MAX = 36 V where ΔIL TON > ΔIL TOFF, so the current escalates and the balance between Equation 31 and Equation 32 occurs at a current slightly higher than the current limit. This must be taken into account in particular to avoid the risk of an abrupt inductor saturation. I L TON Δ V IN V out – DCR L R DS(on) + () I ⋅ – L -------------------------------------------------------------------------------------- T ON () = I L TOFF Δ V D V out DCR L I ⋅ ++ () – L -------------------------------------------------------------- T OFF () = I L TON Δ V IN DCR L R DS(on) + () I ⋅ – L ------------------------------------------------------------------ T ON MIN () V IN L --------- 250ns () ≅ = I L TOFF Δ V D V out DCR L I ⋅ ++ () – L -------------------------------------------------------------- 3T ⋅ SW () V D V out DCR L I ⋅ ++ () – L -------------------------------------------------------------- 12 μs () ≅ = |
|
Link URL |
| Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link to Datasheet | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |