UM1467 datasheet(10/46 Pages) STMICROELECTRONICS

10 / 46 page

UM1467

ST-LINK/V2 installation and development

Doc ID 022172 Rev 1

10/46

ST-LINK/V2 installation and development

STM32F4DISCOVERY board includes an ST-LINK/V2 embedded debug tool interface that

is supported by the following software toolchains:

●

IAR™ Embedded Workbench for ARM (EWARM) available from www.iar.com

The toolchain is installed by default in the C:\Program Files\IAR Systems\Embedded

Workbench 6.2 directory on the PC’s local hard disk.

After installing EWARM, install the ST-LINK/V2 driver by running the

ST-Link_V2_USB.exe from [IAR_INSTALL_DIRECTORY]\Embedded Workbench

6.2\arm\drivers\ST-Link \ST-Link_V2_USBdriver.exe

●

RealView Microcontroller Development Kit (MDK-ARM) toolchain available from

www.keil.com

The toolchain is installed by default in the C:\Keil directory on the PC’s local hard disk;

the installer creates a start menu µVision4 shortcut.

When connecting the ST-LINK/V2 tool, the PC detects new hardware and asks to install

the ST-LINK_V2_USB driver. The “Found New Hardware wizard” appears and guides

you through the steps needed to install the driver from the recommended location.

●

Atollic TrueSTUDIO® STM32 available from www.atollic.com

The toolchain is installed by default in the C:\Program Files\Atollic directory on the PC’s

local hard disk.

The ST-Link_V2_USB.exe is installed automatically when installing the software

toolchain.

●

Altium™ TASKING VX-toolset for ARM® Cortex-M available from www.tasking.com

The toolchain is installed by default in the “C:\Program Files\TASKING directory on the

PC’s local hard disk. The ST-Link_V2_USB.exe is installed automatically when

installing the software toolchain.

Note:

The embedded ST-LINK/V2 supports only SWD interface for STM32 devices.

Refer to the firmware package release notes for the version of the supporting development

toolchains.

UM1467 Datasheet(PDF) 10 Page - STMicroelectronics