STM32L100X6 datasheet(23/102 Pages) STMICROELECTRONICS

23 / 102 page

DocID025966 Rev 5

23/102

STM32L100x6/8/B-A

Functional overview

3.7

Memories

The STM32L100x6/8/B-A devices have the following features:

•

Up to 16 Kbytes of embedded RAM accessed (read/write) at CPU clock speed with 0

wait states. With the enhanced bus matrix, operating the RAM does not lead to any

performance penalty during accesses to the system bus (AHB and APB buses).

•

The non-volatile memory is divided into three arrays:

–

32, 64 or 128 Kbyte of embedded Flash program memory

–

2 Kbytes of data EEPROM

–

Options bytes

The options bytes are used to write-protect the memory (with 4 KB granularity) and/or

readout-protect the whole memory with the following options:

–

Level 0: no readout protection

–

Level 1: memory readout protection, the Flash memory cannot be read from or

written to if either debug features are connected or boot in RAM is selected

–

Level 2: chip readout protection, debug features (Cortex-M3 JTAG and serial wire)

and boot in RAM selection disabled (JTAG fuse)

The whole non-volatile memory embeds the error correction code (ECC) feature.

3.8

DMA (direct memory access)

The flexible 7-channel, general-purpose DMA is able to manage memory-to-memory,

peripheral-to-memory and memory-to-peripheral transfers. The DMA controller supports

circular buffer management, avoiding the generation of interrupts when the controller

reaches the end of the buffer.

Each channel is connected to dedicated hardware DMA requests, with software trigger

support for each channel. Configuration is done by software and transfer sizes between

source and destination are independent.

The DMA can be used with the main peripherals: SPI, I2C, USART, general-purpose timers

and ADC.

STM32L100X6 Datasheet(PDF) 23 Page - STMicroelectronics