DS80C400 (DSTINIm400) Networked Microcontroller EV KIT

2 of 5

COMPONENT LIST (continued)

DESIGNATION

QTY

DESCRIPTION

R6

1

10

W, ±5% resistor (0805)

U1

1

DS80C400 networked

microcontroller

U2, U3

2

HM62W8512BLTT-7UL

512kB RAM

U4

1

AM29LV081B-70EC 1MB flash

U5, U6

2

MAX6365PKA31 reset

controllers

DESIGNATION

QTY

DESCRIPTION

U7

1

MAX1792EUA18 voltage

regulator

U8

1

DS1672U-33 real-time clock

U9

1

DS2502-E48 IEEE MAC

address

Y1

1

14.7456MHz crystal

Y2

1

32kHz crystal

QUICK START

It is highly recommended that the developer use the DSTINIs400 sockets board in conjunction with the

DSTINIm400. The DSTINIs400 was specifically designed to hold the DSTINIm400 and provide the physical

interconnects (Ethernet PHY), as well as the 1-Wire, I

If the developer wishes to implement his or her own design using the DSTINIm400, a 144-pin SODIMM connector

such as the Hirose SX6E-144S-0.8SH is required.

The TINIm400 must be seated correctly into the DSTINIs400 to ensure a proper connection. Insert the TINIm400

into the connector at a 30-degree angle. Place index fingers behind the SODIMM connector and place thumbs on

the top edge of the TINIm400, pressing firmly until it clicks into place or seats with only a millimeter of gold contact

exposed. Press the TINIm400 down parallel to the TINIs400 until the side arms latch into the center of the

semicircular cutouts on the TINIm400.

Note that the flash used on the DSTINIm400 limits applications to a maximum of 2x clock multiplier mode with the

included 14.7456MHz crystal. Use of the 4x clock multiplier mode results in unstable operations.

FOR MORE INFORMATION

TINI platform details can be found at www.maxim-ic.com/TINI. The TINI Specification and Developer’s Guide

(Addison-Welsey, 2001) is an invaluable resource when developing with the TINI platform. Download a free copy

from our website at www.maxim-ic.com/TINIguide.

DS80C400 INFORMATION

For more information about the DS80C400 network microcontroller, please consult the DS80C400 data sheet

available on our website at www.maxim-ic.com/microcontrollers.

ADDITIONAL RESOURCES

For detailed information about the initial setup and use of the TINI platform, refer to Application Note 612: Getting

Started with the TINIm400 (DS80C400) Verification Module at www.maxim-ic.com/appnoteindex.

DS80C400 Networked Microcontroller Data Sheet: www.maxim-ic.com/DS80C400

Microcontroller Website: www.maxim-ic.com/microcontrollers

I

Companies, conveys a license under the Philips I

conforms to the I

SPI is a trademark of Motorola Inc.