UG:003

vicorpower.com

Applications Engineering: 800 927.9474

Page 3

6

Test point for Secondary Control (SC)

7

Output voltage points are designed to accommodate #10 hardware and Panduit ring lugs.

8

Output connector (J01) for mating with VTM-CB providing Vout and VC. As shown on the

schematic (Figure 2) there are four pins dedicated to the + Out, four for the -Out, and two for the

VC. Each contact is rated for 3 A. The excess capacity afforded by these pins can facilitate

testing multiple VTM-CBs from a single PRM-CB using an appropriate wiring harness and mating

connector. This may also be achieved using the large pads of Item 7.

9

Output scope jack (J02). Headers H01 and J01 are 0.100" spacing, 10 position female,

manufactured by Sullins Electronics and available from Digi-Key as part # S5519-ND.

Below is the schematic for this PCB. Double clicking the image will launch Adobe Acrobat to

allow you a better view.

Recommended Hardware

QTY

Description

Manufacturer P/N

4

ring lug

Panduit LCAS6-10-L

Kit # 26647 contains:

4 #10-32 screw

4 #10 flat washer

4 #10 lock washer

4 #10 hex nut

All hardware is stainless steel except the ring lug.

Kit # 26647 is included with the Customer Evaluation Board.

Figure 2

PRM-CB schematic diagram