MS8607 datasheet(3/4 Pages) HUMIREL

3 / 4 page

MEAS MS8607 DCS FOR ZedBoard

Digital Pressure and Humudity Sensor

SENSOR SOLUTIONS /// MEAS MS8607 DCS DEVELOPMENT KIT

07/2016

Page 3

USB-to-microUSB cable for UART communications

A computer with a card reader to write to the SD card and to host a terminal emulator

The following steps will guide you through setting up the hardware platform:

1. First, if you have not connected your computer to a ZedBoard or MicroZed device before, you will likely need to download

and install the Silicon Labs CP2104 USB-to_UART driver. The setup guide for installing the driver can be found at the

address below: http://www.zedboard.org/sites/default/files/documentations/CP210x_Setup_Guide_1_2.pdf

2. Next, attach the SD card to your computer via a card reader or through the built-

in SD card slot. Download the “boot.bin”

file that pertains to the MS5637 from the software link and copy it onto the SD card so that it is the only file present on the

file system.

3. Safely eject the SD card from your computer. Insert the SD card into the card slot on the back of the ZedBoard.

4. Connect the MS8607 digital pressure s

ensor to the “JC” Digilent Pmod™ port of the ZedBoard (1), ensure that jumpers

JP7, JP8, JP9, JP10, and JP11 are configured such that the ZedBoard will boot from the SD card on start-up (2), and

ZedBoard, MicroZed and Digilent Pmod

™ are trademarks.

MS8607 Datasheet(PDF) 3 Page - Humirel