EC4304C

1.5A, Hysteretic, High Brightness

LED Driver with Internal Switch

Page 3 of 8

4F06N-Rev.F001

Functional Block Diagram

Functional Description

The EC4304C is a simple high-efficiency, continuous mode inductive step-down converter. The device operates with

an input voltage range from 7V to 40V and delivers up to 1.5A of output current. A high-side current-sense resistor

sets the output current and a dedicated PWM dimming input enables pulsed LED dimming over a wide range of

brightness levels. A high side current-sensing scheme and an on-board current setting circuitry minimize the

number of external components which is required while delivering LED current with +5% accuracy, using a 1%

sense resistor.

Adjusting Output Current

The device contains a low pass filter between the ADJ pin and the threshold comparator and an internal current limiting

resistor between ADJ and the internal reference voltage. This allows the ADJ pin to be overdriven with either DC or pulse

output current are given in the applications section by:

The value of the output current is 1A at 0.1Ω (0.5A at 0.2Ω) and this is a calculated output current when the ADJ terminal is

1.25V floating.

Shutdown Mode

Taking the ADJ pin to a voltage below 0.2V for more than approximately 100μs will turn off the output, and supply current

will fall to a low standby level of 20μA nominal.

Soft-Start

The device has inbuilt soft-start action due to the delay through the PWM filter. An external capacitor from the ADJ pin to

ground will provide additional soft-start delay, by increasing the time taken for the voltage on this pin to rise to the turn-on

threshold and by slowing down the rate of rise of the control voltage at the input of the comparator.

With no external capacitor, the time taken for the output to reach 90% of its final value is approximately 500

μs. Adding

capacitance increases this delay by approximately 0.5ms/ nF.

Inherent open-circuit LED protection

If the connection to the LED(s) is open-circuited, the coil is isolated from the LX pin of the chip, so the chip will not be

damaged. Unlike in many boost converters, where the back EMF may damage the internal switch by forcing the drain

above its breakdown voltage.