S70GL02GS datasheet(12/19 Pages) CYPRESS

12 / 19 page

Document Number: 001-98296 Rev. *J

Page 12 of 19

S70GL02GS

DC Characteristics

Notes

1. ICC active while Embedded Algorithm is in progress.

2. Not 100% tested.

3. Automatic sleep mode enables the lower power mode when addresses remain stable for a designated time.

4. VIO = 1.65V to VCC or 2.7V to VCC depending on the model.

5. VCC = 3V and VIO = 3V or 1.8V. When VIO is at 1.8V, I/O pins cannot operate at >1.8V.

6. During power-up there are spikes of current demand, the system needs to be able to supply this current to insure the part initializes correctly.

7. If an embedded operation is in progress at the start of reset, the current consumption will remain at the embedded operation specification until the embedded operation

is stopped by the reset. If no embedded operation is in progress when reset is started, or following the stopping of an embedded operation, ICC7 will be drawn during

the remainder of tRPH. After the end of tRPH the device will go to standby mode until the next read or write.

8. The recommended pull-up resistor for RY/BY# output is 5k to 10k Ohms.

9. For all other DC current values, refer to the S29GL-128S_01GS_00 datasheet.

Device ID, Word 3

(Base) + 0Fh

2201h

Secure Device Verify

(Base) + 03h

For S70GL02GS highest address sector protect:

XX3Fh = Not Factory Locked

XXBFh = Factory Locked

For S70GL02GS lowest address sector protect:

XX2Fh = Not Factory Locked

XXAFh = Factory Locked

Sector Protect Verify

(SA) + 02h

xx01h/01h = Locked, xx00h/00h = Unlocked

Table 5. DC Characteristics

Parameter

Description

Test Conditions

Min

Typ

(Note 2)

Max

Unit

ILI

Input Load Current

VIN = VSS to VCC, VCC = VCC max

+0.04

±2.0

µA

ILO

Output Leakage Current

VOUT = VSS to VCC, VCC = VCC max

+0.04

±2.0

µA

ICC4

VCC Standby Current

CE#, RESET#, OE# = VIH, VIH = VIO

VIL = VSS, VCC = VCC max

140

200

µA

ICC5

VCC Reset Current (Notes 2, 7)

CE# = VIH, RESET# = VIL,

VCC = VCC max

ICC6

Automatic Sleep Mode (Note 3)

VIH = VIO, VIL = VSS ,

VCC = VCC max, tACC + 30 ns

612

VIH = VIO, VIL = VSS,

VCC = VCC max, tASSB

200

300

µA

ICC7

VCC Current during power up

(Notes 2, 6)

RESET# = VIO, CE# = VIO, OE# = VIO,

VCC = VCC max,

106

160

Table 4. Autoselect Addresses in System (Continued)

Description

Address

Read Data (word/byte mode)

S70GL02GS Datasheet(PDF) 12 Page - Cypress Semiconductor

S70GL02GS Datasheet(HTML) 12 Page - Cypress Semiconductor

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19

Datasheet Download

Link URL