EV6001DN-00C – MONOLITHIC FLYBACK/FORWARD DC-DC CONVERTER

NOTICE: The information in this document is subject to change without notice. Please contact MPS for current specifications.

Users should warrant and guarantee that third party Intellectual Property rights are not infringed upon when integrating MPS

products into any application. MPS will not assume any legal responsibility for any said applications.

EV6001DN-00C Rev 1.0

www.MonolithicPower.com

5

3/11/2009

MPS Proprietary Information. Unauthorized Photocopy and Duplication Prohibited.

© 2009 MPS. All Rights Reserved.

QUICK START

1. Attach input voltage 43

≤ VIN ≤ 53V and input ground to VIN and GND pins respectively.

2. During startup EN should be left HIGH or unconnected.

3. Connect Power Supply terminals to:

a. Positive (+): VOUT

b. Negative (–): VOGND

4. Turn power supply on and the board will automatically startup.

5. To use Enable function, apply a digital input to EN pin. Drive EN with 2.5V-5V to turn on the regulator,

and drive EN less than 0.7V to turn it off.