FH35C datasheet(9/12 Pages) HIROSE

9 / 12 page

FH35C Series●0.3 mm pitch, 0.9 mm height, back flip type dual-sided FPC connector

[Operational Method]

BConnector Handling and Precautions

1. Initial mounted status (before inserting FPC)

2. FPC insertion method

3. Confirmation of inserted FPC (when the top contact is used)

These connectors are delivered with the actuator in an open

position,removing the need to operate the actuator before inserting

the FPC.

[Caution]

•Do not close the actuator if the FPC has not been inserted yet.

•If the actuator is closed without the FPC, it can narrow the contact

gap and increases the insertion force.

❶ Ensure that the FPC is held parallel to the surface of the PCB and is then completely inserted into the

connector.

[Caution]

•Do not insert the FPC if actuator is closed.

•If the actuator is closed and if the FPC is twisted during insertion, it can cause contact deformation and / or

contact failure.

Proper insertion

Skewed insertion

Shallow insertion

❶ By visually comparing the edge of the connector housing opening with the exposed FPC pattern, faulty

insertion conditions such as a skewed or shallow insertion can be prevented.

These connectors are small and thin, so care needs to be used when handling this

product. Please refer to this section after confirming the following points:

❶

ＦＰＣ

FH35C Datasheet(PDF) 9 Page - Hirose Electric