RF63W datasheet(73/91 Pages) HOPE

73 / 91 page

ADVANCED COMMUNICATIONS & SENSING

Page 73 of 91

RF63

Tel: +86-755-82973805 Fax: +86-755-82973550 E-mail: sales@hoperf.com http://www.hoperf.com

7.5. Reference Design

It is recommended that this reference design (i.e. schematics, placement, layout, BOM,) is replicated in the final

application board to guarantee optimum performance.

7.5.1. Application Schematic

Figure 56: Reference Design Circuit Schematic

The reference design area is represented by the dashed rectangle. C12 is a DC blocking capacitor which protects

the SAW filter. It has been added for debug purposes could be removed for a direct antenna connection if there is

no DC bias is expected at the antenna port. Please note that C10 and C11 are not used.

7.5.2. PCB Layout

As illustrated in figures below, the layout has the following characteristics:

•

very compact (9x19mm) => can be easily inserted even on very small PCBs

•

standard PCB technology (2 layers, 1.6mm, std via & clearance) => low cost

•

Its performance is quasi-insensitive to dielectric thickness => minimal design effort to transfer to other PCB

technologies (thickness, # of layers, etc...)

RF63W Datasheet(PDF) 73 Page - HOPE Microelectronics CO., Ltd.