Factsheet 05.000

April 2020

These specifications are subject to change without notice.

04/29/2020

© 2020 Greenliant

1

S71461-01

GLS FS0019 Rev. 00

GLS87DPxxxx3 / GLS87BPxxxx3 PX Series

Industrial / Commercial Temp SATA M.2 ArmourDrive™

Features

• Industry Standard SATA Host Interface

–

SATA 1.5Gb/s, 3Gb/s and 6Gb/s

–

SATA Revision 3.2

–

ATA/ATAPI-8 compliant

–

Supports 48-bit address feature set

–

Native Command Queuing (NCQ)

up to 32 commands

• Performance

–

Sequential data read: Up to 550 MB/s

–

Sequential data write: Up to 500 MB/s

(measured using 128 KB transfer size)

• Power Management

–

3.3V power supply

–

Host initialized power management (HIPM)

–

Device initialized power management (DIPM)

• Power Consumption

–

Active mode:

1TB: < 1800mW

512GB: < 1520mW

256GB: < 1450mW

128GB: < 1350mW

64GB: < 1250mW

32GB: < 1100mW

–

Idle mode: < 325mW

–

Slumber mode: < 15mW

–

DevSleep mode (optional): < 5mW

• Supports TRIM and SMART Commands

• Data Protection

–

Secure erase / Data sanitization

• Reliability

–

Mean Time Between Failures (MTBF):

2 million hours

• Integrated Current Detector

–

Protects from inrush current and generates

reset during power-up and power-down to

prevent inadvertent writes

• 20-Byte Serial Number

–

Factory pre-programmed unique ID

• Built-in ECC

–

Uses advanced LDPC bit error detection and

correction optimized for 3D NAND

• NAND Configuration

–

3 bits per cell (3D TLC NAND)

• Endurance

–

Program/Erase (P/E) cycles: 3K

• Operating Temperature Range

–

Industrial: -40°C to 85°C

–

Commercial: 0°C to 70°C

(SSD case temperature reported by SMART)

• M.2 2242 and 2280 Form Factors

–

32GB-256GB: 22mm x 42mm x 3.10mm /

22mm x 80mm x 3.10mm

–

512GB: 22mm x 42mm x 3.50mm /

22mm x 80mm x 3.50mm

–

1TB: 22mm x 80mm x 3.50mm

–

Double-sided (DS), B+M key

• All Devices are RoHS Compliant

Product Description

The GLS87DP032G3 / 064G3 / 128G3 / 256G3 /

512G3 (2242 form factor) and GLS87BP032G3 /

064G3 / 128G3 / 256G3 / 512G3 / 001T3 (2280 form

factor) Industrial and Commercial Temperature SATA

M.2 ArmourDrive™ PX Series modules (referred to as

“M.2 ArmourDrive” in this datasheet) are high-

performance, high-reliability solid state drives. They

combine 32, 64, 128, 256 or 512 GBytes, or 1 TByte

of NAND flash memory with an advanced Serial ATA

(SATA) controller on a printed circuit board (PCB).

M.2 ArmourDrive is ideal for applications that require

removable form factor and more reliable data storage.

SATA M.2 solid state storage technology is widely

used in industrial computers, test and measurement

instrumentation,

multi-functional

printers,

medical

equipment,

security

and

surveillance

systems,

network servers and digital signage. These removable

solid state drives (SSDs) surpass traditional hard disk

drives (HDDs) in their small size, security, reliability,

ruggedness and low power consumption.

The SATA SSD controller with built-in advanced

NAND management firmware communicates with the

host through the standard SATA protocol. It does not

require any additional or proprietary software such as

the Flash File System (FFS) and Memory Technology

Driver (MTD). The firmware effectively optimizes the

use of NAND flash memory’s program/erase (P/E)

cycles and minimizes write amplification.

M.2 ArmourDrive’s advanced NAND management

technology

improves

endurance,

enhances

data

security and helps prevent data corruption during

unexpected power failure events. This innovative

technology

combines

robust

NAND

controller

hardware error correction capabilities with advanced

wear-leveling algorithms and bad block management

to improve data reliability and significantly extend the

life of the product.